Cable connector Class E_A 180°, 270° and 360°

During maintenance, expansion and installation of new cabling, it's possible for a cable to be too short. What to do? Replacement of the entire cable will cause additional work and increase cost. Also, certain local conditions may not allow this.

The Cable Connector Class E_A is the intelligent solution for a simple extension or connecting of data cable without the need for special tools. Thanks to its compact design and the angled variants, it can be used in a wide variety of applications, even in confined spaces. With a Class E_A compliance, links with up to 10 GBit/s can be achieved without any problems. The cable connector is therefore a problem solution for almost any network infrastructure, and should be included in every toolbox as basic equipment!

Variants

Lots of possibilities with the 180 °, 270 ° and 360 ° variants

The Cable Connector Class E_A is available in three variants. The variants differ in the cable direction.

The angled variants 180°, 270° and 360° can be used to connect cables in a wide variety of situations.

Class E_A 180°

Class E_A 270°

Class E_A 360°

Benefits

Application Examples

Infrastructure relocation: e.g. workstation

Application Cable Connector: infrastructure relocation

Cable extension: e.g. cable too short

Application Cable Connector: cable too short

Repair: e.g. defective cable

Application Cable Connector: defective cable

Installation options

Known assembly principle

Technically, the Cable Connector Class E_A is based on the installation principle of the METZ CONNECT C6_Amodul. This results in not only a system of the products, but also a consistent and easy installation.

Mounting video: cable connector class E_A 180°

Mounting video: cable connector class E_A 270° and 360°

Relocation of existing infrastrucrure with C6_Amodul

If the C6_Amodul was used in an existing infrastructure, a relocation can be performed more easily and quickly since the loading piece of the C6_Amodul can be used in the Cable Connector Class E_A. Through this, only one side has to be connected again.

Accessory

Click & fix 19" carrier for cable connector

19" cable connector bracket for use as a consolidation point, for moving distributors or complete distribution cabinets.

Part Number: 130863T101E

More information about Click & Fix 19"

Additional Material

Brochure "Cable Connector Class E_A"
Product Page: Cable Connector Class EA 180°
Product Page: Cable Connector Class EA 270°
Product Page: Cable Connector Class EA 360°
News-article: Click & fix 19"

Do you have any questions on this topic?

Then simply contact your METZ CONNECT employee using the link below:

Your Contact Person

Cable connector Class EA 180°, 270° and 360°

Cable connector Class E_A 180°, 270° and 360°